Latest videos

  1. 20ft Rocket Candy Fuse. 4 Seconds. Can It Be Done?
  2. PCB Death Match 001: 1oz vs 2oz Copper
  3. Combine Laser and Lowrider CNC Table

Series Resistor Calculator

Resistors in a chain, one after another, with the same current through each one. Set R1, drag R2, and add more resistors if you like. Watch the total resistance and how the voltage splits between them. You can also click or drag on the graphs.

How it works

Every resistor in series carries the same current, because there’s only one path. The total resistance is just the sum:

R total = R1 + R2 + R3 …
The current is I = Vin ÷ R total.

Each resistor’s voltage is I × R, so the bigger resistor gets the bigger share. Two resistors in series with a wire tapped off the middle is a voltage divider: see the Voltage Divider Calculator.

Handy shortcuts

  • The total is always bigger than the biggest resistor. The first graph shows this: however small R2 gets, the total never drops below the dashed line.
  • Two equal resistors in series give double. Ten equal ones give ten times.
  • A much smaller resistor in series barely changes anything. It gets only a sliver of the voltage.
  • The biggest resistor gets the biggest share of the voltage, and the most power.
  • One open (broken) resistor anywhere in the chain stops the current everywhere.

Watch out

A short across one resistor (a solder bridge) dumps its voltage onto the others. Check that each remaining resistor can handle the extra power. You can try it here: type 0 for one resistor and watch the power in the rest go up.